Page 1 of 1

Question

PostPosted: Thu Jun 17, 2010 11:34 pm
by Turquoise Dragon
Okay, quick question - I've noticed that, on multiple occasions, people have rolled/run/walked straight through my mines, without them blowing. They will clearly pass straight through the line (primary fire mine), yet not set it off. Is this merely a bug in the system, or a case of some sort of hacking? Thanks.

Re: Question

PostPosted: Fri Jun 18, 2010 12:06 am
by Roflraptor
It's a glitch.

Re: Question

PostPosted: Fri Jun 18, 2010 1:03 am
by Turky
An fps manipulation or a screenshot will get through those.

Pro tip: Don't rely on screenshot mines to hold the objective.

Re: Question

PostPosted: Fri Jun 18, 2010 8:32 am
by Turquoise Dragon
Turky wrote:Pro tip: Don't rely on screenshot mines to hold the objective.


Yeah, I've been finding that out.

Re: Question

PostPosted: Fri Jun 18, 2010 8:53 am
by Max Rambone
I roll through trips quite regularly and I never yews screenshots to do it.

~archi

Re: Question

PostPosted: Fri Jun 18, 2010 8:32 pm
by GUARD!AN
Max Rambone wrote:I roll through trips quite regularly and I never yews screenshots to do it.

~archi


Yeah a lot of people mix up screenshotting with just rolling through shitty mines.

Re: Question

PostPosted: Fri Jun 18, 2010 9:24 pm
by Max Rambone
I think it may just be about timing....

Like if you cross the line in just the right point of your roll, you don't trip it.

Would be a fun korri experiment.

~archi

Re: Question

PostPosted: Fri Jun 18, 2010 9:50 pm
by Turky
Also keep in mind for the proxy (secondary) mines that there's a a delay of a few seconds after you lay they mine, before it can be triggered. So I will also often slip past a set of mines that's just been laid and manage to not set them off.